NEC GammaCompMD QA Uživatelský manuál stáhnout pdf (Strana 116)

GammaCompMD QA Client User Manual

NOTE: As no duplicate check is performed for asset IDs, the same ID may be used for

multiple displays such as using a group name. However, care should be taken, since it will be

more difficult to distinguish these IDs in log information which is collected by the

GammaCompMD QA server.

OK button Saves any changes and closes the dialog box. The OK button

cannot be clicked unless the Operator Name is entered.

Cancel button Closes the dialog box without saving any setting. However, any

changes that were applied by clicking the Apply button cannot be

returned to their previous state.

Apply button Applies any changes but does not close the dialog box. The Apply

button cannot be clicked unless the Operator Name is entered.

7.7.1.5. Alert Setup

This dialog box is used to set error limits for measured values compared to predefined target

values. You can also select whether to issue an alert (warning) when a preset limit is

exceeded during the measurement.

When Alert Setup is clicked in Administrator, the Alert Setup dialog box, as shown

in Figure 100, is displayed.

For every alert item, there is a checkbox option:

・ To display a dialog box to the related display of the local workstation.

・ To send alert information to the server in a GammaCompMD QA network

environment when an alert is issued.

NOTE: Set the required preset values before executing a white luminance measurement,

conformance test, or QA test.

Immediately after Alert Setup is clicked in Administrator, the White Luminance tab is shown.

The other setup dialog boxes can be displayed by clicking the tabs where Conformance (1),

Conformance (2) and Others appear.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 181 182

Žádné komentáře

NEC GammaCompMD QA Uživatelský manuál Strana 116