NEC Express5800/R110f-1E Průvodce nastavením stáhnout pdf (Strana 68)

NEC ESMPRO Manager Setup Guide

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the IP address of the

management LAN port for the Standby BMC to the form.

Subnet Mask1 Enter the subnet mask that is specified on LAN2 of the BMC

configuration for the managed component.

If the managed component is a fault tolerant server, you should enter the

subnet mask of the management LAN port for the CPU/IO module 1 to

the form.

If the managed component is a server which has EXPRESSSCOPE

Engine SP3(2BMC model), you should enter the subnet mask of the

management LAN port for the Standby BMC to the form.

CHECK:

・*1 If NEC ESMPRO Manager is installed on Linux system, “SNMP” is not supported.

CHECK:

・*2 If a self signed certificate is installed on the managed server for HTTPS

communication, a setting to allow it is required. Refer to “1.1 Setup Flow” for

detailed information.

CHECK:

・*3 On “Environment” – “Auto Registration Setting List” screen, you can manage a list

of username/password and authentication key. All entries in the list are used for

auto registration every time.

The following screen shows an example.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 124 125

Žádné komentáře

NEC Express5800/R110f-1E Průvodce nastavením Strana 68