NEC Over Frame Kit Manuál

Procházejte online nebo si stáhněte Manuál pro Příslušenství pro ploché obrazovky NEC Over Frame Kit. NEC Over Frame Kit Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 2
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
Extienda la lámina protectora sobre una superficie plana, por ejemplo un escritorio, y coloque el
monitor sobre ella. Nunca apoye el monitor sobre un borde ya que ello puede causar daños al mismo.
Ajuste la parte superior del marco y la parte inferior con los tornillos incluidos en el embalaje.
Ajuste las cantoneras a ambos lados de la parte superior e inferior del marco.
Ajuste la parte derecha e izquierda del marco con los tornillos incluidos en el embalaje.
NOTA: Utilice sólo los tornillos que se le han proporcionado. El uso de otros tornillos puede
resultar en daños al monitor.
Étalez une feuille de protection sur une surface plane, comme un bureau, et placez-y le moniteur.
Attention de ne pas faire reposer le moniteur sur ses côtés : risque d’ endommager l’ écran.
Fixez le cadre du haut et le cadre du bas en utilisant les vis fournies.
Fixez les cornières des deux côtés du cadre du haut et du cadre du bas.
Fixez le cadre droit et le cadre gauche en utilisant les vis fournies.
REMARQUE : n’ utilisez que les vis fournies. Si vous utilisez d’ autres vis, vous risquez
d’ endommager le moniteur.
フレームトップ 1
フレームボトム 1
フレームライト 1
フレームレフト 1
コーナー 4
ジョイント 4
ネジ (M415)12
セットアップマニュアル
Frame top x 1
Frame bottom x 1
Frame right x 1
Frame left x 1
Corner x 4
Joint x 4
Screws (M4 x 15) x 12
Setup manual
1.ィスレイをマット毛布など柔らいものの上にかせます
2.レートッ とフレーボト それぞれ属のネジ 3 使用して取りけます。
3.ーナ 4 個をフレームップとフレーボトムの両端取り付けます
4.レーライ フレームフト それぞれ付属ネジ 3 本を使用して取りけます。
注意付属のネジ以は使用しないください
Spread the protective sheet on a flat surface, such as a desk, and place monitor on it. Be careful to
never rest monitor on its edges. Damage may occur.
Attach the Frame top and Frame bottom with supplied screws.
Attach the corners to the both side of Frame top and Frame bottom.
Attach the Frame right and Frame left with supplied screws.
NOTE: Use only supplied screws, if you use other screws, it may cause damage to monitor.
1x cadre du haut
1x cadre du bas
1x cadre droit
1x cadre gauche
4x cornières
4x joints
12x vis (M4 x 15)
Manuel de montage
Marco superior x 1
Marco inferior x 1
Marco izquierdo x 1
Marco derecho x 1
Cantoneras x 4
Juntas x 4
Tornillos (M4 x 15) x 12
Manual de instalación
Oberes Rahmenteil x 1
Unteres Rahmenteil x 1
Rechtes Rahmenteil x 1
Linkes Rahmenteil x 1
Eckteil x 4
Verbindungsstück x 4
Schrauben (M4 x 15) x 12
Einrichtungshandbuch
Telaio superiore
1 Telaio inferiore
1 Telaio destro
1 Telaio sinistro
4 Angolari
4 Giunti
12 Viti (M4 x 15)
Manuale d’ installazione
monitor
Legen Sie die Schutzfolie auf eine ebene Oberfläche, beispielsweise einen Tisch, und platzieren den
Monitor darauf. Achten Sie darauf, den Monitor niemals auf seinen Kanten abzustellen; andernfalls kann
er beschädigt werden.
Montieren Sie das obere Rahmenteil und das untere Rahmenteil mit den mitgelieferten Schrauben.
Bringen Sie die Eckteile an beiden Seiten des oberen und unteren Rahmensteils an.
Montieren Sie das rechte Rahmenteil und das linke Rahmenteil mit den mitgelieferten Schrauben.
HINWEIS: Verwenden Sie ausschließlich die mitgelieferten Schrauben. Die Nutzung anderer
Schrauben kann den Monitor beschädigen.
Stendere il foglio protettivo su una superficie piatta, come un tavolo, ed appoggiarvi il monitor.
Prestare attenzione a non appoggiare mai il monitor sui suoi lati. Diversamente si provocano danni.
Attaccare il telaio superiore ed inferiore usando le viti fornite in dotazione.
Attaccare gli angolari ad entrambi i lati del telaio superiore ed inferiore.
Attaccare il tealio destro e sinistro usando le viti fornite in dotazione.
NOTA: Usare solo le viti fornite in dotazione, l’ uso di altre viti può provocare danni al monitor.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
4.
1.
2.
3.
4.
(KT-46UN-OF)
(KT-46UN-OF2)
(KT-55UN-OF)
Zobrazit stránku 0
1 2

Shrnutí obsahu

Strany 1 - (KT-55UN-OF)

Extienda la lámina protectora sobre una superficie plana, por ejemplo un escritorio, y coloque el monitor sobre ella. Nunca apoye el monitor sobre un

Strany 2

1. フレームトップ とフレームボトム をそれぞれ付属のネジ 3 本を使用して取り付けます。それぞれのフレームの間にはジョイント を挟みます。2. コーナー 4 個をフレームトップとフレームボトムの両側に取り付けます。3. フレームライト とフレームレフト

Komentáře k této Příručce

Žádné komentáře