NEC M362X Uživatelský manuál stáhnout pdf (Strana 111)

100

5. Using On-Screen Menu

Selecting Communication Speed [COMMUNICATION SPEED]

ThisfeaturesetsthebaudrateofthePCControlport(D-Sub9P).Itsupportsdataratesfrom4800to38400bps.The

defaultis38400bps.Selecttheappropriatebaudrateforyourequipmenttobeconnected(dependingontheequip-

ment,alowerbaudratemayberecommendedforlongcableruns).

NOTE:Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

SettingIDtotheProjector[CONTROLID]

YoucanoperatemultipleprojectorsseparatelyandindependentlywiththesingleremotecontrolthathastheCONTROL

IDfunction.IfyouassignthesameIDtoalltheprojectors,youcanconvenientlyoperatealltheprojectorstogether

usingthesingleremotecontrol.Todoso,youhavetoassignanIDnumbertoeachprojector.

CONTROL ID NUMBER ��Select a number from 1 to 254 you wish to assign to your projector�

CONTROL ID ��Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID set-

ting�

NOTE:

• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupport

theCONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)

• Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.

•PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControl

ID.

Assigning or Changing the Control ID

1. Turn on the projector.

2. PresstheIDSETbuttonontheremotecontrol.

 TheCONTROLIDscreenwillbedisplayed.

 IftheprojectorcanbeoperatedwiththecurrentremotecontrolID,the[ACTIVE]willbedisplayed.Iftheprojector

cannotbeoperatedwiththecurrentremotecontrolID,the[INACTIVE]willbedisplayed.Tooperatetheinactive

projector,assignthecontrolIDusedfortheprojectorbyusingthefollowingprocedure(Step3).

3. PressoneofnumerickeypadbuttonswhilepressingandholdingtheIDSETbutton

on the remote control.

Example:

 Toassign“3”,pressthe“3”buttonontheremotecontrol.

 NoIDmeansthatalltheprojectorscanbeoperatedtogetherwithasingleremotecontrol.

Toset“NoID”,enter“000”orpresstheCLEARbutton.

TIP:TherangeofIDsisfrom1to254.

4. ReleasetheIDSETbutton.

 TheupdatedCONTROLIDscreenwillbedisplayed.

NOTE:

•TheIDscanbeclearedinafewdaysafterthebatteriesarerundownorremoved.

•AccidentallypressinganyoneofthebuttonsoftheremotecontrolwillclearcurrentlyspeciedIDwith

batteriesremoved.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 164 165

Žádné komentáře

NEC M362X Uživatelský manuál Strana 111