NEC VT770 Uživatelský manuál stáhnout pdf (Strana 36)

5. Repeat steps 3 and 4 to correct keystone distortion.

6. After completing Keystone correction, press the ENTER button.

The Keystone screen will disappear.

• To perform Keystone correction again, press the 3D REFORM button

to display the Keystone screen and repeat above steps 1 to 6.

NOTE:

•Turning on the projector will reset the previous correction setting values if the projection angle is changed from the last use.

If the projection angle is the same as in the last use, the previous correction setting values are retained in the memory.

To use the previous correction setting values after changing projection angle, select "Manual" in "Keystone" from the menu. See

page 87.

To return the 3D Reform correction setting values to the factory preset, press and hold the 3D REFORM button for a minimum

of 2 seconds.

• Each time the 3D REFORM button is pressed, the item will change as follows: Keystone

→

Cornerstone

→

None

→

Keystone

→

...

For information on “Cornerstone”, see “Correcting Horizontal and Vertical Keystone Distortion (Cornerstone) on page 44.

•You can zoom in or out, while keeping an image that was corrected using "Keystone", without again having to make those

adjustments.

3. Projecting an Image (Basic Operation)

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 125 126

Žádné komentáře

NEC VT770 Uživatelský manuál Strana 36